PDA

View Full Version : sump seal?


jimmyp
23-05-2007, 09:15 PM
where can i get a sump gasket, or summit to seal it if it's not a gasket???

any help apreciated

ta much

semtex
23-05-2007, 09:52 PM
there is no gasket jimmy, all you need is get some proper jointing silicone from your local motor factors and use that, the way to seal it best is remove sump clean every last bit of the old stuff off then put a nice plump bead all the way round , now leave that for 20 mins or so then offer it up to the block put it on finger tight to start off , leave it again for another 20 odd minutes then tighten it up nice and tight , theres probably a torque setting but ft will suffice

jimmyp
23-05-2007, 10:32 PM
cheers semtex, any makes to look out for, or will any silicone seal do?

infamous aidy
24-05-2007, 05:36 AM
jimmy, i know its against your nature but in under no circumstances take a hole saw to your sump!

John Laverick
24-05-2007, 07:41 AM
Just be VERY careful you don't put too much on. The last thing you want is some dropping into your sump and getting sucked into [and blocking] the oil pick up!