106 Rallye Register Forum

106 Rallye Register Forum (http://www.106rallyeforum.com/forum2008/forum.php)
-   Problems, Servicing & Repairs (http://www.106rallyeforum.com/forum2008/forumdisplay.php?f=77)
-   -   Welding inner front wings ! (http://www.106rallyeforum.com/forum2008/showthread.php?t=95353)

Mou1t 29-09-2017 07:39 PM

Welding inner front wings !
Welding the inner front wings tomora and making a new front bumper holding plate as it had rotted off !

Any of you guys done this ? Think am gona risk leaving the wings on 🙈🙈



Cris B 29-09-2017 11:07 PM



Yes. Several times :rolleyes:

You can still buy some of the panels off 106parts.com, but they are not cheap.

Most folk just fabricate their own and weld them in. If you are thinking of DIYing, get looking at the mig-welding.co.uk forum

Mou1t 30-09-2017 09:24 PM

Welded my own plates in.... drying in blue hammerite as I sup this tin !
Had a problem with the washer jet pipes melting however ! Any 1 no if I can get a connector to add a new section of pipe or do you have to replace the full section ?

Cris B 30-09-2017 11:41 PM

The standard pipe is a quite a hard plastic. Any decent DIY shop will carry some 1/4" flexible plastic pipe you can run as a replacement from the washer bottle pump to the scuttle. There's normally a connector in the pipework there.

Mou1t 01-10-2017 04:41 PM

It's Sorted ��

All times are GMT. The time now is 11:48 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.