View Single Post
Old 03-04-2018, 04:20 PM   #6
freddy
REGISTERED FORUM USER - NON MEMBER
 
Join Date: May 2007
Location: Belgium
Posts: 26
User Gallery
its highly recommended to have at TDC a clearance of 1.5mm at full lift in order to be on the safe side ,the best method will be to install the head with a used gasket time the cam properly and turn the engine few times , do not forget to put some clay on the pistons and in case that you fell the lightest restriction once you turn the engine stop immediately or you might risk damaging your valves, i would advice that you will check this point in advance to avoid any surprises later on
freddy is offline   Reply With Quote