Thread: New rear axle
View Single Post
Old 11-08-2017, 09:32 PM   #2
MHR1294
106 RALLYE REGISTER MEMBER
 
Join Date: Dec 2013
Location: Perth
Posts: 189
User Gallery
The drums should come off with a hammer. this may split the wheel bearing.

If you need to swap the stub pins that the bearing sits on, it simply hammers out. the end of it is dimpled for hammering out with a drift. don't just hit the end with a hammer or it'll mushroom.

You can cheat and do what I did, to remove the drum simply hammer the stub pin back with the drum still on after removing the nut. this stops the bearing from splitting!

Everything else is bolt on.
MHR1294 is offline   Reply With Quote