Thread: New rear axle
View Single Post
Old 29-08-2017, 09:18 PM   #6
MHR1294
106 RALLYE REGISTER MEMBER
 
Join Date: Dec 2013
Location: Perth
Posts: 189
User Gallery
Quote:
Originally Posted by moult View Post
Right guys !
Removed the old beam today... goin to replace the brake lines as there slightly corroded. The brake bias value looks like it's seen better days as well but don't really wana buy a new 1 of them. Unsure if it seized cause it isn't under tension cause it's off the car but the bolt is loose to the spring. Has any1 bypassed this ?
Another question I have is are the rear brake protectors needed ? Mine are old and pretty bent ?

Any help would be great ! Thanks
Yeah I've no problem using discs with no compensator/bias valve. I also don't run backing plates and not had any issues so far.

I think the lack of compensator is only an issue if you swap the master cylinder to a 2 port one. I've heard the back and front end likes to switch places when braking hard!
MHR1294 is offline   Reply With Quote